Installation and Calibration: 1 - Pull the Car Key out from the ignition. 2 - Find OBD2 connector(*) in your car and Plug in Super OBD2 3 - Insert the key into the ignition and twist the key to the first stage. (Do not start the car) 4 - Press the reset buttom for about 5 sec. After releasing the buttom, just wait for a while about 30-54 sec. (Super OBD2 will communicate and establish connection with ECU) 5 - Start up the engine. 6 - Super OBD2 will recognize your vehiclend
our driving habits, after around 200 km/150 miles driving and thus Super OBD2 will adjust itself to match your car perfectly for more fuel saving. Does your car have OBD2 connector? On-Board Diagnostics, or "OBD," is a computer-based system built into all 1996 and later light-duty vehicles and trucks, as required by the Clean Air Act Amendments of 1990. OBD systems are designed to monitor the performance of some of an engine's major components including thoseesponsible for
ontrolling emissions. OBD2 necessarily for cars: - Sold after January 1, 1996 in the USA - Sold after January 1, 2001 in the European Union Where located OBD2 connector in your car? 1 Driver's side, underneath dasboard, in the area under the steering column, 2 Driver's side, underneath dasboard,between the driver-side door and steering column area 3 Driver's side, underneath dasboard, between the steering column area and the center console 4 Driver's side,ashboard
nstrument/gauge area, between the steering column and center console 5 Driver's side, dashboard instrument/gauge area, between the driver-side door and steering column 6 Center console, vertical surface left of vehicle centerline 7 Center console, vertical surface right of vehicle centerline or on passenger side of center console 8 Center console, horizontal surface in front passenger area. Certificates : CE / FCC / RoHS
