Cigarette Lighter with Alligator to OBD2 16 Pin Male Connector Power Cable :Powered by any jump starter with a 12V outlet into an OBD II Memory Saver.Plug it into the OBD Male connector of the vehicle, plugging the cigarette connector into the clip cords, hooking it up to a 12V battery source.Note:This device can work with any 12V DC power source, including jump starter, DC 12V Lead-acid battery, or another car’s DC 12V power outlet.
Super Long 10ft (3meters) Cable: plenty long until you try connecting it to another car's battery or cigarette lighter. In this way, you can change your car battery, also by get the alternative 12V power source from another car, when you not have a jump starter on hand.
8 amp fuse built into the memory saver, better reliable on overload protection. Powered by any jump starter with a 12V outlet into an OBD II Memory Saver. Interface connector between a 12V DC power source and vehicle's OBD II port. Preserves vehicle codes and electronic presets. Replacing a car battery on older vehicles used to be simple!! You unhook the old battery and install the new one.
Work no problem as all ODBII ports :It works on any vehicle with OBDII which is 1996 and later (You will be plugging one end into it). It is not needed or required to change your battery. It is used to keep the memory of you radio setting and other memory computer controlled devices on the vehicle (EMCU for example.) It is used as a convenience as to not erase the memory.
EASY TO REPLACE :Should you not have jump starter (or Lead-acid battery) on hand, and the device can also get the 12v power supply from cigarette lighter of another good car. Just insert the Cigarette lighter plug to this car and insert into 16 pin plug to the OBD port of the car you want to replace battery.
