Dual H Bridge DC Stepper Motor Controller L298N Module for Arduino / Due and Raspberry Pi
The L298N driver module, using ST's L298N chip can directly drive two 3-30V DC motor, and provides a 5V output interface can 5V single-chip circuitry to supply, support 3.3VMCU control, you can easily control the DC motor speed and direction, you can also control the 2-phase stepper motor, smart car essential.
Features:
Driver: L298N Dual H Bridge DC Motor Driver IC
Driven part of the terminal supply area Vs: 5 V ~ 35 V; such as the need to take power within the board, the supply area Vs: 7 V ~ 35 V
Driven part of the peak current Io: 2A
The logical part of the terminal supply area Vss: 5 V ~ 7 V (can take power within the board 5 V)
The logical part of the operating current range: 0 ~ 36mA
Control signal input voltage range:
Low:-0.3V
High: 2.3V
Enable signal input voltage range:
Low: -0.3
High: 2.3V
Maximum power consumption: 20W (when the temperature T = 75 Deg C)
Storage temperature: -25 Deg C ~ 130 Deg C
Other Extensions: control of direction indicators, the logic part of the plate to take power interface.
Functions: control the direction indicator, power indicator, current detection, the logic part of the board to take power interface.The L298N driver module, using ST's L298N chip can directly drive two 3-30V DC motor, and provides a 5V output interface can 5V single-chip circuitry to supply, support 3.3VMCU control, you can easily control the DC motor speed and direction, you can also control the 2-phase stepper motor, smart car essential.
