Zippo ZP-2425 Wick

Name: Zippo ZP-2425 Wick
Brand: Zippo
Price: 120 EGP
Availability: InStock

Current Price ,Not Good

120.00EGP

121.50

Buy Now Amazon Prime

Lowest Price 40.00
Highest Price 175.00
Recent Price Drop -1.2%

Similar Products

Zippo ZP-2425 Wick	159.00 EGP +1%	Sellers	Buy Now
Zippo Classic Lighter - Yellow	936.00 EGP -10%		Buy Now
Zippo Lighter Refill Gas	120.00 EGP -4%		Buy Now
Zippo Classic Lighter, 710100001332	2,499 EGP		Buy Now
Zippo Classic Lighter - 710100000180	3,141 EGP -10%		Buy Now
Zippo Founders Lighter - Brushed Chrome	950.00 EGP -6%		Buy Now
Zippo Lighter Silver Refillable Gas	125.00 EGP		Buy Now
Zippo Lighter Flints - 6 Pack - Gold [2406N]	150.00 EGP -8%		Buy Now
Zippo Leather Lighter Pouch w/Loop, Brown	1,341 EGP -10%		Buy Now

Brand: Zippo
Model: ZP-2425
Zippo ZP-2425 Genuine Wick

Flint & Wick Co-pack

Get all of your lighter tune up essentials with this co-pack.

3 individual flint cards
3 individual wick cards
Fits all zippo windproof lighters

Trimming the Wick

Step 1: First, gently pull up the wick using tweezers or pliers until the clean wick appears. Pull from as far down as possible to avoid ripping the wick.

Step 2: Using scissors or wire cutters trim the wick. This should be performed once or twice per year for optimal performance. After 2-3 trimmings the wick should be replaced.

Replacing the Wick


Step 1 First, remove all components from the bottom of the lighter insert; flint bolt, felt pad, packing material, and the old wick. To replace the wick, insert a new wick either downward through the chimney or through the bottom of the lighter insert.	Step 2 Next, bend the top portion of the wick over the chimney to hold it on place during assembly. Then, carefully reinstall the packing material in the same order it was taken out. As you are reinstalling in small pieces weave the wick between the padding in an 'S' pattern.	Step 3 Reinstall the felt pads over the flint tube and secure it with the flint spring. Be sure the flint does not fall out during this process.	Step 4 Once your components are reinstalled put the insert back into the case and trim the wick. The lighter is ready to go.

Replacing the Flint


Step 1 First remove the insert from the lighter case. Using a small bolt driver or a coin, slowly remove the spring. The spring has tension so be sure it doesn't fly away.	Step 2 Remove the remaining piece of flint by gently tapping the insert against a hard surface. Once it is removed, use an unfolded paper clip to remove any stubborn flint slivers or residue from the flint tube. Insert a new flint into the flint tube.	Step 3 Replace the flint spring and turn clockwise until tight. If the bolt isn't fully tightened the lid will not close.	Step 4 After fully tightening the spring you may want to keep extra flints under the felt pad so you always have them handy for future use. Put the insert back into the lighter case and make sure the lid can fully close. if the flint wheel binds, turn the wheel backwards a few times.