ElecGear 8X ALPS 10K Replacement Trimmer Potentiometer Sensor for PS3, PS4, Xbox One, Elite, Switch Pro Wireless Gaming Controllers, Trim Pot Resistors Repair Parts for ALPS Analog Joystick

[ALPS 10K Potentiometer] – The OEM side trim pot resistor was made by ALPS. It widely fits the wireless controllers with ALPS joysticks inside: PS3, PS4 DualShock 4 series (PS4, Slim and Pro), Xbox One series (Xbox One, One S|X), Elite Series 1 and 2, and newest Xbox Series S|X. It also works with Nintendo Switch Pro and some 3rd party controllers like ‘Scuf’ and ‘Razer Raiju Ultimate’
[Compatibility] – This 10K ALPS version is not interchangeable with the orange version made by Favor Union (FU). Also be noticed: ALPS potentiometers come in two different resistance values. Never judge its value by its color. Please make sure the resistance value is 10K ohm before ordering. (Be noticed: choose 2.1K ohm version for PS5 DualSense and some rare PS4 controllers.)
[For most joystick problem] – The 3Pin trimmer potentiometer sensor needs to be replaced when the controller has the problem of creeping, stuttering, a blind spot, a dead spot, a dead zone, or it wouldn't center after years of wear and tear. De-soldering the unit with only 3 prongs will be much more easier than replacing the entire 14Pin joystick module
[Reminder of Replacement] – Make sure you have basic soldering skills and some de-soldering supplies like an electronics solder iron and small gauge solder. Use a pair of pliers to separate the problem sensor off the thumbstick component. A metal pick helps to clear the holes in the PCB. Re-soldering the new unit in is a breeze. Please remember to calibrate the new control sticks in settings