AONA Mini Heat Gun, Portable Handheld Hot Air Gun for DIY Embossing Shrink Wrapping PVC Drying, 220V Electrical Rubber Stamp Heat Tool, Electric Phone Repair Tool

Mini Hot Air Gun, 220V Portable Heat Shrink Gun for Embossing Wrapping Drying Crafts Electronics DIY

Keeping 5-6cm distance from work and about a 45 degree angle to heat until it is completed. It not only can add its hardness, but also its brightness

100% Brand New and High Quality ABS and PC plastic material, it is equipped with the stainless steel bracket to rotate 100 degrees. It is Very compact and durable, practical

There are heat vents in left and right sides to decreased the internal temp and extend its lifetime

Our excellent compact heat gun can be used for heating shrinkable film, embossed powder, rubber stamp, the polymer clay will become hard and bright after using the gun
The temperature can not be adjusted, but in theory, it can reach at about 200 degree within a few seconds abstractly. But do not use it more than 10 minutes, just you can turn off then turn on again for working continuously

Specification:

Material: Plastic ABS+PC
Cable length: 39.4in /100 cm
Rated Power: 300W
Rated voltage:220v
Power: 50-60Hz
Working time: 10 minutes
Power type: AC power supply
Type: Constant temperature

Warning

-Do not touch with water! Do not touch the hot nozzle.
-Do not use outdoor. Keep it out reach of children. Keep 5-6cm distance between the heat tool and item.
-Do not use more than 10 minutes continuously to prevent overheated.
-This hot air gun is specially made for DIY, it can’t not use in industry aspect

Package includes:
1 x Hot Air Gun