82.95SAR
70.15-
Lowest Price 43.27
-
Highest Price 144.00
-
Recent Price Raise 18.2%
82.95SAR
70.15
Before tire pressure monitoring system works normally properly, the body control module will record ID information of each position in the tire pressure sensor; and use the following methods to read the tire pressure sensor after replacing a tire or wheel speed sensor. Please refer to the specific methods as follows:
Step 1 - Enter leaning mode
Set the gearshift lever to P,Put the ignition switch to “ON”,Enter the interface of tire pressure display by DIC,DIC shows Press Set / Ctrl to re-learn Press “Set / Ctrl”,The turn signal is lighted for 3 seconds and the horn beep sound twice to enter the learning mode
Step 2 - Read tire pressure sensor information
Start from the front-left wheel,Make the J-46079 or Diagnostic Tool antenna up against the valve core position & close to the rim of the tire sidewall, tire pressure tool starts by the start switch,Successful to read the tire pressure sensor information when the horn bleeps once
Step 3 - Same method to read other tire pressure information
Follow the instuction above to read tire pussure of the front-right, rear-right, rear-left wheels,Turn signals is lighted for 3 seconds and the horn bleeps twice when the learning is complete